Bob’s second outing
Thursday, November 20th, 2008Bob has had a bit of minor surgery. I replaced the Darlington transistor motor driver with a L293D chip. Thing is, I forgot that the 293 has relatively large losses so Bob was much slower...
Bob has had a bit of minor surgery. I replaced the Darlington transistor motor driver with a L293D chip. Thing is, I forgot that the 293 has relatively large losses so Bob was much slower...
Line Follower First run
Monday, November 17th, 2008All the bits are together and the processor code tested. Bob should know when he is on track and how far out he is when he is off track. Time to get him running on the test track...
Line Follower Sensors Setup
Sunday, November 16th, 2008With the sensors installed and the robot pretty well complete, it is time to see if they can actually do the job they were designed for. the idea is that the line of sensors will be able to measure the robots offset from the centre of the line over as ...
Line follower sensor experiments
Monday, November 10th, 2008The simplest arrangement for a line follower is probably two sensors with digital outputs. As long as one can see the line and the other can see the background, the controller is happy otherwise it must turn left or right as appropriate. I was after something a bit more ...
Bob the Line Follower - the build
Monday, November 10th, 2008Once all the parts have been chosen and the schematics drawn, it is just a case of getting on with building the bits...
New line follower robot
Monday, November 10th, 2008Line followers are a perennial favourite of the small robot builder. It is not hard to make something that will bumble about and follow a line marked out on the floor. the technology can be very simple but the same basic idea is used in sophisticated robots on factory ...
Subscribe